Instructions for Hardrock Cleaners and Strippers
NC7893 No Rinse Neutral Marble Cleaner
Directions for Floors
-
Dust, mop, sweep, or vacuum the floor to remove any loose dirt that may be
present.
-
For normal cleaning mix 1
part Hardrock
Cleaner and 16 parts water. (Approximately 1 cup per gallon
of water) For heavy soiled floors mix 1 part cleaner to 6 parts
water. Note: To avoid
"foaming" be sure to put the water in the container first and add the cleaner
to the water.
-
Damp mop floor with a clean mop set aside for use only on your stone floor.
-
Allow the floor to dry completely before allowing any foot traffic. If water
streaks occur, simply buff them off with a soft cloth or
white buffing pad.
-
Every 2 or 3 months, wet the grout lines with the "heavy" mix and scrub them
with a bristle brush. Follow with the normal damp mopping procedure.
-
Since
Hardrock
Cleaner is a neutral cleaner you may mop as often as needed.
We suggest mopping at least once per week.
Directions for Upper Surfaces
-
Mix
Hardrock
Cleaner with water using the same instructions as floors above.
-
Pour into a spray bottle and spray on to the surface or apply with a sponge
or soft cloth and scrub vigorously. Wipe dry with a clean, soft cloth.
CS 7025 Hardrock Cleaner/Stripper
To Clean Marble, If no sealer is present, mix 1
part
Hardrock
Marble Cleaner/Stripper to 12 parts water.
To Remove Wax mix 1 part cleaner/stripper to 4 parts water.
To Remove Sealer mix 1 part cleaner/stripper to 2 parts
water.
For Floors, apply liberally with mop. Allow to stand 3 to
5 minutes, then agitate with brush or white pad. Pick up with mop or wet
vac. Rinse thoroughly, with special care to grout lines. Let dry completely
before polishing process.
For Counters, Tables, etc., apply liberally to marble surface
with sponge. Allow to stand 3 to 5 minutes, then agitate with brush or sponge.
Rinse thoroughly and allow to dry before applying polish.
